The 12V output panel cannot provide power for the 12V2A camera for a long time, please buy it carefully!The working time is approximately 8-10 hours.(It can power 12V low-power hunting cameras.)

Features：

1. IP66 waterproof design
2. Built-in 2Pcs 18650 batteries, single 3000mah, total capacity 6000mah.
3. Charged during the day to the battery to store electrical energy, it still provides a stable power output at night without being restricted by sunlight. Other solar panels do not include batteries and cannot provide power at night.
4. The power switch, power supply and charging indicator light are intuitive and obvious.
5. Vertical 120° up and down adjustment of the bracket to facilitate charging and improve conversion efficiency.
6. Monocrystalline silicon has better charging efficiency, and it can still be charged in rainy days.
7. The glass panel is easy to clean dust and not easy to be scratched.
8. Provide 5V2A or 12V/1A stable current to supply the equipment with stable and reliable power.
9. Battery reverse connection protection, effectively placing the battery reverse connection to damage circuit components.

1. For the first use, be sure to leave the panel without any equipment connected to it and charge it in the sun for more than 2 days.
2. Press the switch and the red light is on, indicating that the battery voltage is above 2.8V and placed in the sun. The green light is on to indicate that it is charging, and the green light is off to indicate that it is fully charged.
3.If the battery voltage is lower than 2.8V, in order not to affect the battery life, recharge, the panel will stop outputting voltage. Please restart the solar panel after charging.

Instructions for powering the camera

Please make sure whether your camera is a low-power camera, the one that can sleep is low-power, and the continuous working time that can't sleep is short, about 8-10 hours.
As shown in the figure below, it is a low-power camera. Some people start to work and no one goes into sleep mode. (The purchase does not include the camera with this link, only the solar panel)

Power Output

It can provide power for routers, low-power cameras, mobile phones and other electronic devices.
If you use a high-power load, the working time increases with the power, and the working time will decrease.

Purchase options

1,NO Battery 5V DC: one 4W Solar panel with DC 3.5*1.35 mm size. Without battery, you can purchase 18650 battery to install and use.

2,With Battery 5V DC: One 4W Solar panel with 2pcs batteries and DC 3.5*1.35 mm size.

3,No Battery 5V USB: one 4W Solar panel with micro-usb connector. Without battery, you can purchase 18650 battery to install and use.

4,With Battery 5V USB: One 4W Solar panel with 2pcs batteries and micro-usb connector.

5,No Battery 5V TYPE C: one 4W Solar panel with micro-usb connector. Without battery, you can purchase 18650 battery to install and use.
6,With Battery 5V TYPE C: One 4W Solar panel with 2pcs batteries and micro-usb connector.

7,No Battery 12V DC: one 4W Solar panel with DC 5.5*2.1 mm size,it has no micro-usb connector. Without battery, you can purchase 18650 battery to install and use.
Note: This panel only supplies power to the dormant camera. The 12V2A camera only works for 8-10 hours, please be aware.

8,With Battery 12V DC: One 4W Solar panel with 2pcs batteries and DC 5.5*2.1 mm size. it has no micro-usb connector.
Note: This panel only supplies power to the dormant camera. The 12V2A camera only works for 8-10 hours, please be aware.

Parameter introduction

*This is a 4W solar panel with battery, Built-in 18000mah high-capacity battery.5V/12V voltage output.
*The cable length is 2m
*Waterproof grade IP66

Battery selection

Up to 6 18650 batteries can be installed

You can install more batteries by yourself